pcwizz.net



Inside the librem 13

Date: 18/03/2016

Disclaiming bias

I have already taken the bottom my librem 13, as I like to act like the average prole, so I can give an intial report on the internal layout and wire runs.

To be honest I took the bottom off to upgrade the memory and slot in an ssd, but I thought it might be some next level autism to write about it. I'm not really an expert on PCB design or laptop internal layouts, but I have taken lots of things appart.

My favourate laptop for build quaility is in fact my x200, as everything was covered in a plastic dust/splash proof wrap, meaning everthing had remained extreemly clean despite it being many years old. I don't really expect anything other than thinkpads to compare to the exeptional attention to detail found in the x200

I did spend a couple of summers durring college/high school years churning out workstations and servers wich is also why I have an unhealthy obsetion with cable ties, cable tension, bendradius and screw types. People very easily overlook important factors such as cable tension tending towards over tought cables that are both a pain in the ass to perform maintanace on and degrading to the cables lifespan. That said I have no formal training in the matter only habits I have contracted from fellow neckbeards or formulated myself.

Initial inspection

It looks like pretty much any other modern laptop internal: A compact motherboard situated in the top left, a respectable battery tacking up the enirity of the palm rest, a single slot for sdram, a minipcie (populated with the wifi card), a 2.5" sata drive and an m.2 sata connector to the right. As you would expect of an i5 thier is a fan possitioned in the middle exasting heat out of a rear ven from a thick copper heat pipe. The rear vent apears to be unfiltered and run right the way alon the back of the case. the Heatsink had a small block of what looks to be thermal tranfer foam to utalice the metal bottom cover; the bottom of the laptop gets warm.

There was a fair bit of that matt black tape in use to keep wires in place, mostly arround the wifi module. It seems that some of the cable could have been made a little shorty for tidyness, but it might be better in the long term for maintainence. The wires for the cmos battery were not afflicted by the tape but had been looped affectionatly round the connector in one elipiptical cool; I dare not touch it for fear that it would never go down again.

The screws attached the board to the case seemed to be small black painted screws. I didn't look arround closly for a ground other than the one for the wifi card which was a wire with the end traped under a screw, not a screw one would ever have reason to remove so it's fine with me.

Populating the M.2 sata

It's a standard insert at 45 degrees then lower to horrizontal and screw affair. The only niggle is that they don't seem to populate the screw hole if you don' order it with a M.2 sata drive; I had to find my own screw.

Changing the RAM

They had put some kingston memory in there which is fine; I just wanted more than I had ordered with the machine. There is only a single dim slot that works in the way you think it does if you have changed ram in a laptop before. I went for a 1.35v dim I think that is what was in there I didn't check.